Plastic chastity cage with PA lock (4 base rings·2 keys)

A plastic chastity cage built for people with a Prince Albert piercing. A separate locking pin engages the PA so the cage cannot work its way forward, which is a different way of holding than an ordinary cage that relies on the base ring alone. The set contains the cage, four base rings, a mechanical lock with two keys, and a storage pouch.

The PA pin holds the cage

A cage that uses only the base ring tends to slide forward when relaxed. This one passes a pin through the PA piercing to hold the cage in place, so it does not come out. The dimension guide in the photos gives the pin diameter as 4mm. If your piercing gauge is smaller than that, it will not go through, so check first.

All four rings are included

The base rings come in inner diameters of 38mm, 43mm, 48mm, and 52mm, and every one of them is in the box. You do not pick a size when ordering, so you try them once it arrives and decide, which cuts down on sizing mistakes. The ring and the cage clip together.

A light plastic cage with slits

The cage length is listed as 58mm and 67mm in the dimensions shown in the photos. Wide slits are cut into the sides and the top, so air passes through and water runs straight out. Being plastic, it is lighter than a metal cage and is not cold in winter.

Before you use it

This product assumes you already have a PA piercing, and without one the locking pin cannot be used. Using it on a piercing that has not healed will damage the hole, so wait until it has fully settled. Plastic is lighter than metal, but it can spread under force, so the strength of the restraint itself does not match metal.