Flat-plate chastity device (3mm steel·vulva cutout)

A chastity device that blocks with a single steel plate rather than a cage. The plate is 3mm thick with a stylized vulva shaped cutout in the middle. It screws onto a heavy stainless steel ring and is held against the body with a leather strap.

A single plate, not a cage

Most chastity devices wrap around and confine what is inside, whether as a tube or as a barred cage. This one does not wrap, it blocks the front. The plate sits directly in front of the glans and removes any room to grow forward, so the erection itself is pressed down. That is far more direct pressure than an enclosing design, and it is exactly what the product is built for.

Two uses for the central cutout

The hole through the middle of the plate is shaped into a vulva, which gives it its cosmetic role. At the same time, a urethral sounding rod can be passed through that opening and used together with the device. The design assumes both of these will be combined in a BDSM setup.

The leather strap and the hex key

The plate is fixed to the ring with screws that tighten with a hex key. In other words, this is not a padlock you turn a key in, it takes a tool to release. On top of that, a leather strap with snap fasteners goes around the body to stop the plate from shifting. With the strap fastened, nothing moves out of position while it is worn.

Before you use it

The original description says outright that this is not for people who like comfort. Because the plate blocks the front, an erection hurts, and long wear leaves pressure marks. Start with short sessions, and take it off if the pain does not settle. The lock is a hex screw, so it cannot be released without the key. Always check that the key is within reach before you put it on.