KAMA leather strap-on (· 3 included)

The harness has two parts. A ring mounts on the leather panel at the front, and a strap of cotton blended with rubber thread runs around your waist. The box contains 3 stainless steel rings in different sizes, and a dildo is not included. You pick a dildo with a suction base separately and pass it through a ring, so the harness works with several dildos you already own instead of being tied to one product.

Three rings cover a range of thicknesses

The way it holds is simple. Push the dildo through the ring from back to front and the base, which is wider than the shaft, catches and stops. The closer the fit between dildo and ring, the less it wobbles when you thrust. The three sizes of 3.2cm, 3.8cm and 5cm cover almost every suction base dildo on the market. Use 3.2cm for slim ones and 5cm for large ones.

No sizing to do

The strap is a single elastic band with no step adjustment. It stretches to your body as soon as you put it on, so the fitting step disappears every time you use it. Measure your waist or hips where you plan to wear it, and if the figure falls between 72 and 110cm it fits. Below 72cm the band does not tighten enough, and above 110cm it pulls taut and leaves marks.

It holds up under a heavy dildo

The rings are stainless steel, so they do not give way under the force of thrusting. They are held by 3 snaps rather than sewn into the leather panel, so you can swap to a different size in a few seconds. Close all 3 snaps before use. If even one is open, the leather panel twists when you push hard.

How to pick the ring

Do not choose a roomy ring just because it is easier to fit. Choose the one that matches your dildo most closely. Even a single size too large lets the dildo wobble with every thrust, which throws off your force and your direction.