Vibrating nipple clamps (2 bullets·wired controller)

A pair of nipple clamps with vibrating bullets attached. The clamps, the bullets and a wired controller make up one set. The screw at the back of each clamp sets the bite and the controller dials set the vibration strength.

The screw sets how hard it bites

Behind each clamp sits a thumb screw, and the further you turn it in the harder the clamp bites. The tips are covered in rubber so metal never touches the nipple directly. The safe way is to start with the screw backed off, put the clamp on at its loosest and tighten it a little at a time.

Bullets and controller

Each clamp has one vibrating bullet hanging from it, and both bullets run by wire to the controller. The controller carries two dials, so the left and right sides are adjusted separately. The product photos list 10 vibration patterns.

The listed measurements

Each bullet is 54mm x 26mm and the controller is 125mm x 45mm. The total weight is given as 113g. The product photos show two versions, one with black bullets and one with silver.

Before you buy

Being a wired product, it limits how you move, and a pulled cable drags the clamps with it. It suits lying down rather than positions with a lot of movement. Nipple clamps often hurt more coming off than going on, so loosen the screw first and lift them away slowly. There is no original description, so the battery type and whether it is waterproof are not confirmed, and the safe approach is to keep it away from water.