Nipple stretcher (clamp·adjustable pull)

A device that clamps the nipple and then draws it outward little by little as you turn a screw. A bolt is mounted on a parabolic stainless steel frame, with a clover shaped clamp hanging from its end. The price is for a pair, that is two pieces.

The harder it pulls, the harder it bites

Clamp the tip of the nipple and turn the nut on the bolt, and the clamp is drawn upward. The clamp is built so that its grip strengthens as it is pulled, which keeps it from slipping off mid stretch. Adjustment follows the turn of the screw, so you can raise the intensity in small increments, almost like reading off a scale. The design works for men and women alike.

The ring that rests on the breast

The ring that goes around the breast is round in cross section. When the pull is applied the ring presses into the breast, and because the profile is not angular the pressure point hurts less. The inner diameter of the ring is 5.3cm. If the breast measures larger than that, the ring will sit in a different position, so measure before buying.

About the stainless steel

The whole piece is rustproof stainless steel. The parts that take the load, such as the screw and the clamp, are metal, so it lasts longer than a plastic equivalent. Wash it with mild soap and a soft brush, and avoid household detergents.

Before you use it

This device sits at the intense end of the range. Blood is blocked where the clamp bites, so sensation disappears if it stays on too long, and tightening further at that point causes injury. The first time, pull only a very small amount, release within a few minutes, and see how your body responds. Take it off slowly, since the pain at the moment blood returns is greater than the pain of putting it on.